Page2
Fuel Gauge, Tank Info' & instrument panel info'
If you have
Libra/Spyder fuel gauge problems then the following may be of interest:-
The fuel tank
used
is from a Rover Metro & the following information
is from a popular car maintenance handbook for the
fuel tank/gauge sender unit.
FULL
TANK of fuel resistance should read 15.5
ohms
HALF TANK of fuel resistance should
read 65 ohms
EMPTY
TANK
resistance should read 270 ohms
We did not use Rover
Metro instrument panel voltage regulator for the instruments.
15/09/2017:- Correction
- When we built our Libra we did not use the Rover or GTM fuel gauge,
instead we used one from an American Classic Instruments Catalogue. In
order to get the gauge to operate with the Rover fuel tank sender unit
we had to put an 18 ohm resistor in series with the gauge and a 1.2
kohm in parallel with the tank sender. In the drawing below the 1.2 kohm resistor across the fuel gauge should be omitted.
n
The chosen instrument now gets :-
Full tank=33.3 ohm (requires 33 ohms).
Half tank = 83 ohms (requires 85 ohms)
Empty tank = 238.4 ohm (requires 240 ohms) .
Here are a few tips -
1. Wiring colours - BL /
W means a Blue cable with a thinner White tracer colour.
2.
W / BL means a White cable with a thinner Blue tracer colour.
The Libra fuel pump
feed,
which has to have the new loom & the old loom, joined under the
left
hand side of the Dash is a (W / Gn) White wire with a Green
tracer
colour.
Beware as there is also
a (Gn / W) Green wire with a white tracer colour which goes to the
Right
Hand rear indicator light.
Back to top of page
